Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CME Codec Question.

Hi, im setting up a trunk CME - AVAYA

How can a revice in CME a call with codec G711ulaw, because avaya its sendme the call with that codec, and CME use G729 per default

Thanks

5 REPLIES
New Member

Re: CME Codec Question.

from CME to AVAYA its working because in dial-peer I set the codec G711ulaw command like this:

Hall of Fame Super Gold

Re: CME Codec Question.

Actually CME phones uses G.711 by default, however it is also true that "dial-peer voice" uses G.729 by default so you have to set as g.711 as needed.

Now for incoming VoiP calls you will need a dial-peer voice configured with "incoming called-number" and "direct-inward-dial", do you have one ? You can reuse the same DP used for outgoing if you whish.

Hope this helps, please rate post if it does!

New Member

Re: CME Codec Question.

Thanks for reply,

Ok, so if i want to use the same this will be ok:

ext 63.. => Avaya

ext 72.. => CME

dial-peer voice 50 voip

destination-pattern 63..

session target ipv4:10.2.2.1

incoming called-number 72..

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

Hall of Fame Super Gold

Re: CME Codec Question.

Yes. Ignore the reference about direct-inward-dial, for a moment I made confusion about a pots DP.

New Member

Re: CME Codec Question.

Thanks a lot, it working know.

Regards

741
Views
0
Helpful
5
Replies
CreatePlease to create content