I am using CME. after I installed IP phone, then execute #show voice dsp, I noticed that some phones use G.729 and others use G.711. is that normal or do I need to change codec for all phone to use the same codec?
If you see IP Phone to IP Phone call using G.711 that is normal and if IP Phone to PSTN call is using G.729, this is also normal. Without any codec configuration, this behaviour is Working as Designed.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...