07-05-2008 01:42 AM - edited 03-15-2019 11:45 AM
Hi Friends,
I have ATA186 device in order to connect FAX with CME. ATA device have SCCP based ios so tell me can i configure fax through SCCP based ATA with CME. I gone through documents available on cisco but i think i have to change ATA software from SCCP to H323.
Please suggest me what to do.. waiting for your swift response.
Best Regards
07-05-2008 04:29 AM
Yes, you can try with SCCP. In case of problems you can switch to H.323 or SIP later.
In any case, the most important thing is that, if you are using a digital pots line in the router, configure networck-clock-select 1 for said interface.
09-29-2008 07:23 PM
Yes. Not exactly sure how, but you'd need to enable modem passthrough under the voice service. This sets up the voice call and then lets the ATA and gateway negotiate the codec inside the RTP stream without CME interfering.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide