Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME cut calls

Have a Cisco 2811 with IOS c2800nm-entservicesk9-mz.124-22.T.bin, CME Version 7.0(1) two VIC2-4FXO towards PSTN. Alls Call to the PSTN are cut after 2.55 min. approximately

, from any of the FXO ports, Can someone help me with this.

Thanks

6 REPLIES
Hall of Fame Super Gold

Re: CME cut calls

Can you collect "debug vpm signal" and "debug voice ccapi" with "term mon" ?

Ideally, you do this after configuring "service timestamps debug datetime msec localtime".

New Member

Re: CME cut calls

Send debug CCapi and VPM, the calls of test was to the numbres 9005622442010 and 90056991598950.

Re: CME cut calls

Too many calls here and it's all muddled up. Can you get this during a quiet period and get the debugs together?

New Member

Re: CME cut calls

ok, again sending the debug

Re: CME cut calls

The ccapi debugs say the fxo hung up first, and the vpm debugs say the ip phone hung up first.

Can't come to a conclusion when you're getting the debugs separated.

A little note that may be helpful, and for anyone else that may read this - debugs are never more helpful when they're captured separately.

-nick

Hall of Fame Super Gold

Re: CME cut calls

Jose, beside the good advice from Nick, can you try 12.4(20)T2 that is perhaps a little more stable ?

180
Views
0
Helpful
6
Replies