Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME Design Question

I am a newb to the CME world, so excuse my ignorance.

We have two PRI's existing.  I am looking at 5 remote sites, and we would like to share the PRI's for these remote sites.

I know in the CUCM enviornment, this can be easily done, but not sure if this is possible in CME.  Any ideas?

2 REPLIES
VIP Super Bronze

Re: CME Design Question

You can use H.323 or SIP dial peers between the CME routers that prefer the PRI for outbound calls. You can also set aside blocks of your DID range on the PRIs for the remote site and use dial peers to forward those calls to the correct CME router.

You will need to use caution to ensure that emergency calls (911) always use a local port.

Hall of Fame Super Silver

Re: CME Design Question

As stated by Jonathan you accomplish this via dial peers, essentailly you configure the GWs as IP-IP GW and redirect the calls to the main GW via voip dial-peers, in order to enable IP-IP feature you need to allow that by using the following commands:

voice service voip

allow-connections h323 to h323

allow-connections h323 to sip

allow-connections sip to h323

allow-connections sip to sip

I put in both H323 and SIP as I am not sure which one you would prefer, and then you have bi-directional dial peers pointing to and from the main site's GW.

HTH,

Chris

143
Views
0
Helpful
2
Replies
CreatePlease login to create content