Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME- Dial out problem with corlist

Hi All;

I have CME configured with cor. I have two dial-peer one for International access and other for national access as shown below.

**International access**

dial-peer voice 21 pots

corlist outgoing International

preference 2

paramspace callsetup after-hours-exempt TRUE

destination-pattern 8.T

incoming called-number .

direct-inward-dial

port 0/0/0:15

other one is

** Nationla access***

dial-peer voice 20 pots

corlist outgoing National

preference 1

destination-pattern 9.[1-9]T

incoming called-number .

direct-inward-dial

port 0/0/0:15

Most of the things works fine axcept the national numbers not internation with second digit zero (0) like i 6054532 and 9054532, 802066. I ma using 9 to dial out and to dial international i am using 8 to dial out. In pots dial-peer voice 20 i have destibation pattern 9.[1-9]T for national calls.I dont know how router CME blocking only calls with second digit zero not including 9 to dial out. rest is working fine.

waiting for your reply.

1 REPLY
Hall of Fame Super Gold

Re: CME- Dial out problem with corlist

Hi,

try making you DP more specific and the problem should go away. eg:

dial-peer voice 21 pots

destination-pattern 900[1-9]......T

prefix 00

dial-peer voice 20 pots

destination-pattern 9[x-y]....T

replace x and y above with the valid range of digits for national calls. In the example 9 is used for all calls, as for COR to work is not necessary that you use separate digits.

177
Views
4
Helpful
1
Replies