I have 2 site SITE A with CUCM 9.2 with the extension numbers 9XXX and I wan to call from SITE B which has CME . To do this I created Inter cluster trunk on the CUCM9.0 and created dial peer on CME to receive the call and works perfectly.
The CME site users uses digit 9 to take external line to call on mobile or land lines.
When I make a dial peer with destination pattern 9... it works but they are not able to take external line since 9 is already used. I want a dial peer like this listed below
destination pattern 29xxx where it should strip first digit 2 and send 9xxx.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4