Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME Dial Tone Delay

All,

I have some users on CallManager Express 8.6 that get a significant delay (1+ seconds) from the time they hit the speaker button to the time they get dial tone.  The setup is phone--->3750 stack-------->ASA5510-------------->2911 running CME.  Sounds like a network issue  to me but was looking for some hints on where to start the troubleshooting.

Thanks.  All replies rated.                

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: CME Dial Tone Delay

You should have the ASA connnect directly to the internet, or use another router for that, or even eliminate the ASA completely.

But never have ASA in between CME and phones.

Thanks for the nice rating and good luck!

3 REPLIES
Hall of Fame Super Gold

CME Dial Tone Delay

If you could eliminate the firewall from the path, as it is best practice in voice networking, you would probably solve this problem and avoid potential others.

New Member

CME Dial Tone Delay

OK.  The network is such that the router doing the Internet connections is the same one doing CME. Since this is the Internet router doesn't that usually go on the outside then the firewall on the inside of the router or did I not show up class on Networking 101?

Hall of Fame Super Gold

Re: CME Dial Tone Delay

You should have the ASA connnect directly to the internet, or use another router for that, or even eliminate the ASA completely.

But never have ASA in between CME and phones.

Thanks for the nice rating and good luck!

552
Views
5
Helpful
3
Replies