Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME, Displaying CallerID and Station-ID

CallerID is displayed,

But Station ID is not, why?

Here is the config

voice-port 0/1/0

connection plar opx 0

description desc-1

station-id name st-1

station-id number 555

caller-id enable

3 REPLIES

Re: CME, Displaying CallerID and Station-ID

IOS will try to get caller-id first, and then station id if caller-id fails.

This means you have a calller-id error.

Try using the correct cptone for your country?

-nick

New Member

Re: CME, Displaying CallerID and Station-ID

I get Caller-ID

But at the same time, I want to see Station-ID

Thanks

Re: CME, Displaying CallerID and Station-ID

We will only show one or the other.

This is the order the CME will choose Caller ID:

1) Caller ID (if it exists)

2) Station ID (if it exists)

3) Destination pattern on incoming pots dial peer

It's not possible to display both the caller id and station id. The station ID replaces the caller id if it does not exist.

hth,

nick

472
Views
0
Helpful
3
Replies
CreatePlease login to create content