Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME DSPFARM - max session = 0??

I am trying to setup a call manager express to be able to do conferencing. But I can not enable without putting in max sessions. But max sessions ? shows only "0" as an option. Tips on troubleshooting? Thanks.

Cisco2811ILG(config)#dspfarm profile 1 conference

Cisco2811ILG(config-dspfarm-profile)#max session ?

<0-0> Number of sessions assigned to this profile

sccp ccm group 1

associate ccm 1 priority 1

associate profile 1 register confdsp1

!

dspfarm profile 1 conference

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

codec g729br8

associate application SCCP

shutdown

2 REPLIES
Cisco Employee

Re: CME DSPFARM - max session = 0??

Most probably there is no troubleshooting needed, but just the fact you do not have enough DSPs

HW CFB demands a WHOLE dsp, this means you need the 16 channels available (or if you have pvdm2-8 the whole 8 channels).

Check if you have enough dsp resources available to set a CFB.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: CME DSPFARM - max session = 0??

Arrrgh - you are right.. This CME was purchased before my watched and I assumed it had at least minimal dsp resources. Thank-you.

Cisco2811#sho dspfarm all

Dspfarm Profile Configuration

Profile ID = 1, Service = CONFERENCING, Resource ID = 1

Profile Description :

Profile Service Mode : Non Secure

Profile Admin State : DOWN

Profile Operation State : DOWN

Application : SCCP Status : NOT ASSOCIATED

Resource Provider : FLEX_DSPRM Status : NONE

Number of Resource Configured : 0

Number of Resource Available : 0

Codec Configuration

Codec : g711ulaw, Maximum Packetization Period : 30 , Transcoder: Not Required

Codec : g711alaw, Maximum Packetization Period : 30 , Transcoder: Not Required

Codec : g729ar8, Maximum Packetization Period : 60 , Transcoder: Not Required

Codec : g729abr8, Maximum Packetization Period : 60 , Transcoder: Not Required

Codec : g729r8, Maximum Packetization Period : 60 , Transcoder: Not Required

Codec : g729br8, Maximum Packetization Period : 60 , Transcoder: Not Required

Total number of DSPFARM DSP channel(s) 0

3761
Views
4
Helpful
2
Replies