CME extension Mobility + permanent number for phone
Is there a way to configure CME to allow a phone to have a permanent number and still let a user login to the phone using extension mobility, so essentially the phone has 2 numbers when someone logs into it, and still has the permanent number once a user has logged out?
If you mean you want to let anyone log into EM enabled phone with DN 1000, log in, and end up with DN 1000 + their own EM DN, no, there is no way to do that. The non-EM config is not used to build up the EM, they're static configurations, this would only work if you only use that phone, and have DN 1000 in your EM profile, defeating the whole purpose of using EM.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...