Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME: Force an IP Phone to dial to a specific voice-port

Greetings,

How can I get an IP Phone to dial out using a specific voice-port or voice-ports?

Thanks,


David

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CME: Force an IP Phone to dial to a specific voice-port

See the following link for an explanation and sample config.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801bc341.shtml

Hope this helps.

Brandon

2 REPLIES
Hall of Fame Super Gold

Re: CME: Force an IP Phone to dial to a specific voice-port

Add a dedicated DN for picking the desired line, and put it on dedicated lines button.

Then, use the "trunk" command in ephone-dn, and match that number in a pots DP with the desired port..

Re: CME: Force an IP Phone to dial to a specific voice-port

See the following link for an explanation and sample config.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801bc341.shtml

Hope this helps.

Brandon

199
Views
0
Helpful
2
Replies