Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CME FXO to Centrex long distance code problem

I have a UC520/CME connected to a Centrex switch. With the previous PBX and with a but-set if you dial a long distance number, 9-1-234-564-7890, the Centrex swtich sends back a "tone" that indicates the user needs to then enter an access code. User enters the access code and the call is completed.

Problem: With the UC520 connected, the user is not hearing the "tone" and is not able to enter the access code, therefore long distance calls fail.

Any ideas?

Thanks.

2 REPLIES

Re: CME FXO to Centrex long distance code problem

lets say ur fxo port 0/0/1

u need to have somthing like:

dial-peer voice 9 pots

destination-pattren 91..........

dtmf-relay h245-alphanumeric

port 0/0/1

forward-digits all

or forward-digits [number of digits u wanna send out of ur fxo]

good luck

if helpful Rate

New Member

Re: CME FXO to Centrex long distance code problem

The dial-peers were matching as the calls would get the PBX, but just wouldn't complete a long distance call due to no access.

Strangely enough the problem seems to have resolved itself.

Thanks for the reply.

350
Views
0
Helpful
2
Replies
CreatePlease to create content