Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME G729 Moh and prompt?

I wonder whether there is a way to configure CME using Moh file from flash with g729 codec. Also, is it possible to configure b-acd script to play g.729 codec prompts?

In this configuration, all incoming calls will come from WAN with g.729 codec. If we could configure MoH and Prompts using g729, we could save some transcoding dsp resources. However, I tried save the .au files as g.729 format, but the system could not play the files.

4 REPLIES
Hall of Fame Super Gold

Re: CME G729 Moh and prompt?

What did you used to record in G.729 ?

Most applications do not produce the correct format unless you know very exactly how to do that.

If you go to:

http://pbevila.fastmail.fm/public/Recorder/

there is native tcl/ivr recoder that I wrote. Just change codec to g.729 and see if you have better luck with the prompts produced by that.

I have not tried b-acd in g.29 but I would be curious to know if it works for you.

hope this helps, please rate post if it does!

New Member

Re: CME G729 Moh and prompt?

I copied the g711ulaw files to CCM4, and Call manager convert it to g.729. But it did not work. I wonder whether CME could actually play G729 format, or I might have to use transcoder.

Hall of Fame Super Gold

Re: CME G729 Moh and prompt?

You can check with "debug voice application media state".

New Member

Re: CME G729 Moh and prompt?

The debug result did not show the codec. I will run packet analyzer tomorrow to find out. I am actually wondering whether b-acd could play prompt as g.729.

353
Views
0
Helpful
4
Replies