Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME - GUI adding phones

Hi,

I have a CallManager Express 4.0, I had opened in GUI but I am unable to add the phones. I had downloaded the lates basic files for GUI (cme-basic-4.0.0.1[1]) and GUI Files.

But when I added IP Phone in Router I am able to modify the same in GUI.

Is there any limitation in CME for adding IP Phones.

Please help.

Thanks/Regards

karuna

8 REPLIES
Hall of Fame Super Gold

Re: CME - GUI adding phones

make sure you have "auto-reg-ephone" configured. This way the GUI will recognize new phones.

Please rate useful posts.

New Member

Re: CME - GUI adding phones

Also make sure the phone is connected.

Hall of Fame Super Red

Re: CME - GUI adding phones

Hi Karuna,

Just to add a note to Paolo and Amit's good info. Here is an excellent thread (including Bug#) that explains this situation;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddd19f3/0#selected_message

Hope this helps!Thanks to Jorge from Cisco!

Rob

New Member

Re: CME - GUI adding phones

Thanks a lot for your kind help...

Is there any way to assign Partition and CSS in GUI for Phones.

Thanks in advance.

Regards

Karuna

Hall of Fame Super Gold

Re: CME - GUI adding phones

Karuna, you may be in confusion. CallManager Express don't use CSS and Partions, all the phones are treated equally, and if you want to special things with some of them, there are other means.

Re: CME - GUI adding phones

Karuna,

I think you can use the CORlist options for your Partition and CSS req.

Thanks,

Kumar

New Member

Re: CME - GUI adding phones

Hi,

Is there any way of doing the same in GUI.

Regards

Karuna

Hall of Fame Super Gold

Re: CME - GUI adding phones

Only the latest 12.4-11XJ1 / CME 4.1 has support for assigning COR to a DN using the GUI. However, you still have to configure the COR list in CLI. In general the GUI is so limited that most task are better executed from CLI.

Please remember to rate useful posts.

231
Views
4
Helpful
8
Replies