Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME GUI files

Hi,

I try to access to CME GUI "http://IP_Address/ccme.html" after I login by username and password it shows nothing blank page. I think there is no files for CME GUI on flash. I have attach show version, dir flash:, show telephony-service.

thank you

1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

Re: CME GUI files

Hi

The actually call processing part of CME is built into the IOS.

The GUI is downloaded separately, just be sure that you download the correct version for your version of IOS.. check what you have against this sheet, then get the GUI files from the download pages (www.cisco.com/go/software)

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/33matrix.htm

Regards

Aaron

Please rate helpful posts..

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
2 REPLIES
Super Bronze

Re: CME GUI files

Hi

The actually call processing part of CME is built into the IOS.

The GUI is downloaded separately, just be sure that you download the correct version for your version of IOS.. check what you have against this sheet, then get the GUI files from the download pages (www.cisco.com/go/software)

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/33matrix.htm

Regards

Aaron

Please rate helpful posts..

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

Re: CME GUI files

Hi,

Checking the information that uploaded, I dont see the GUI files in the flash, so what you need to do is download the proper GUI files for you CME and upload those to the routers flash.

After that you need to indicate to the router where to look for those files using the "ip http server" and "ip http path" comand and that should be it.

This link explains how to enable this:

https://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmegui.html

And this one explains how to access it and use it:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/gui/user/guide/cmegui_user.pdf

HTH

Walter Solano

CCNA Voice

Cisco UCCX Specialist

412
Views
0
Helpful
2
Replies
CreatePlease to create content