Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME hunt group loop

I have CME 7.0 and a hunt group with two members in the list

Is the a way to make the group keep cycling so that it is always ringing....dont want call to get to voicemail...

thanks

Colum

6 REPLIES
VIP Super Bronze

Re: CME hunt group loop

Hi,

Give this a go..

ephone-hunt 1

pilot 5000

list 1000, 1001, 1003

final 5000

That way after the first 3 numbers ring, then it should go back to the hunt-pilot

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"

Re: CME hunt group loop

Just a friendly FYI.. With CME 7.0 you can do call blast out of the box. This way all phones in the list ring at the same time. As long as you do not specify a timeout value the call should keep ringing the hunt group.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmecover.html#wp1145800

New Member

Re: CME hunt group loop

I would not take no value in the timeout

thanks for the info on the callblast

New Member

Re: CME hunt group loop

It would not allow me to point the final to the hunt list

thanks

Re: CME hunt group loop

Then create a ephone_DN that forwards back to the huntlist..

VIP Super Bronze

Re: CME hunt group loop

Just Like Kevin said, do the following:

ephone-dn xxxx

CFA 5000 (whatever your hunt pilot number is)

then configure your hunt list final to point to ephone-dn xxxx

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
630
Views
10
Helpful
6
Replies