Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME in SRST Mode with h.323 CUCM - wrong dial-peer matching

Hi All,

I have a question about cme in SRST mode:

We have configured SRST mode with "auto provision all" and SRST works fine.

But when the WAN comes back, the router is still using the cme dial peers instead of the VoIP dial-peer to CUCM (h.323).

I thought that the SRST config will avoid this behavior.

What we have done is giving a lower preference to the lines, but I'm not sure if this is the right way.

I played with different dial-peer hunt commands as well, but I think none will fit the requirement.

Can anyone give me a hint ?

Thanks

Steffen

Sent from Cisco Technical Support iPad App

1 REPLY

CME in SRST Mode with h.323 CUCM - wrong dial-peer matching

Hi Steffen,

When you use the auto provision all command it writes the ephones that register to the actual running config.  Try using auto provision none instead, and/or manually configure the ephones/ephone-dn's and assign preferences to make sure correct dial-peers are being matched.

HTH,

Chris

301
Views
0
Helpful
1
Replies
CreatePlease login to create content