Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CME instead of SRST

I haven't tried this yet, but was just wondering if there are any gotchas/issues when using CME instead of SRST. I was specifically thinking about 2 points:

1) Do you need to ensure the phone loads in CME are the same as CM, or wouldn't it cause the phones to upgrade/downgrade each time if not.

2) Swapping to CME should be straight forward, but how does a phone swap back. Would it still check its primary CM list even though registered with CME. Or would I just create a list in CME that had the CM as primary?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: CME instead of SRST

1. Don't setup tftp on CME, this way the current phone load from CM will be used

2. It works the same way as normal SRST does, when a CM becomes available the phone will wait 120 seconds (default) to register back with it.

HTH,

Chris

4 REPLIES
Hall of Fame Super Silver

Re: CME instead of SRST

1. Don't setup tftp on CME, this way the current phone load from CM will be used

2. It works the same way as normal SRST does, when a CM becomes available the phone will wait 120 seconds (default) to register back with it.

HTH,

Chris

New Member

Re: CME instead of SRST

great thanks. I think I only just realised there is actually a CME-SRST feature, whereas I was thinking about normal CME.

New Member

Re: CME instead of SRST

what is this cme-srst feature you speak of? sounds intriguing...

Re: CME instead of SRST

Hi,

You can read from here:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmesrst.html

Hope it helps, if it does please rate.

Best regards,

- Adrián

219
Views
0
Helpful
4
Replies
CreatePlease to create content