Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CME interfacing another CME

Hi guys,

Originally we had one CME in the network supporting 48 phones. Due to a change order the total number of phones jumped to 78. So we decided to add another CME to the network.

The 2 CMEs are connected to a cisco switch. Both CMEs are on the same VLan. I'm having some problems to interface both CMEs. I know about dial-peer, but it doesn't seem working here since the 2 CMEs are on the same switch and same VLAN. Any ideas of how to solve this problem?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: CME interfacing another CME

Hi, all good but please don't change the value of dscp media from the standard of EF.

8 REPLIES
Hall of Fame Super Gold

Re: CME interfacing another CME

Normal voip DP config should do, what is the problem ?

New Member

Re: CME interfacing another CME

well i don't know how to do voip DP.. Any idea for that?

Hall of Fame Super Gold

Re: CME interfacing another CME

Hi have you ever looked at the cisco documentation? search for example "dial-peer voip".

New Member

Re: CME interfacing another CME

i know dial-peer command and i have used it before, but here there is no router interfacing the 2 CMEs. Basically they are on the same switch and same VLAN, so "session-target ipv4:10.1.30.100" commnand doesn't seem working. I think it's obvious since i only have layer 2 here.

hope you understand what i'm saying!

Hall of Fame Super Gold

Re: CME interfacing another CME

That should work. set codec g711u and no vad, also set incoming-called number xxx for the numbers you receive calls for.

Also if you set session protocol sipv2 under DP, it's easy to see what happens with "debug ccsip message" and "term mon".

New Member

Re: CME interfacing another CME

You should define the follow to allow connections between the two CME, and define dail-peer voice.

I suppose the extensions of phone sets are 7XXX.

voice service voip

allow-connections h323 to h323

h323

!

voice rtp send-recv

!

dial-peer voice 200 voip

destination-pattern 7...

session target ipv4:10.xx.xx.xx

dtmf-relay h245-alphanumeric

codec g711ulaw

ip qos dscp cs5 media

no vad

Hall of Fame Super Gold

Re: CME interfacing another CME

Hi, all good but please don't change the value of dscp media from the standard of EF.

New Member

Re: CME interfacing another CME

the problem has been resolved. Thank you guys.

140
Views
0
Helpful
8
Replies
CreatePlease to create content