Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CME: No more than 2 in Meet-Me

I am running a 2821 with IOS version 12.4(20)T4.

I set up Meet-Me and it was working initially.  I could get several people into a conference.  It's been about 3 months since I set it up.  Today was the first day the client wanted to use it, and it didn't work.  The odd thing is that they were able to get the conference started, a second person could enter the conference, but when a third person tried to enter that person got a busy signal.  I did a shut/no shut on the dspfarm.  I have not tried restarting the router because it's being used pretty frequently until closing time.

Ideas?

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: CME: No more than 2 in Meet-Me

Configure the ephone-dn for the meetme with octo-line

ephone-dn  20  octo-line

or configure dual line with same number 2or 3 as you required.

This will solve your issue

3 REPLIES
Hall of Fame Super Gold

Re: CME: No more than 2 in Meet-Me

Schedule a reload after closing time.

Community Member

Re: CME: No more than 2 in Meet-Me

Yeah, the reboot didn't work.  Even if it did, I am also trying to figure out why it went belly up in the first place.

Community Member

Re: CME: No more than 2 in Meet-Me

Configure the ephone-dn for the meetme with octo-line

ephone-dn  20  octo-line

or configure dual line with same number 2or 3 as you required.

This will solve your issue

252
Views
0
Helpful
3
Replies
CreatePlease to create content