cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
206
Views
0
Helpful
1
Replies

CME no PRI card using AS5300 GW - HELP

petereircom1
Level 1
Level 1

HI,

I have a CME installed on a router with NO pri card. I have this connected to a AS5300 GW, which is currently working for voip on another PBX. I have configured the CME and can make outbound calls ok, but i cannot get the main number to connect to the extensions. I have debuged the CME router (debug ccsip) and i get 404 - not found. I need to know how to point this incoming number to the CME extensions. When i do a sh dial-peer voice sum, it shows POTS ports on the CME ???? i need to get the main PRI number to point to the reception extension.

anyine don ethis before ? if so any ideas on how i get this number to point at the CME extensions ?

thanks

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

That means the number has no match. Likely you will a translation or secondary number on the CME router.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: