Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME no PRI card using AS5300 GW - HELP

HI,

I have a CME installed on a router with NO pri card. I have this connected to a AS5300 GW, which is currently working for voip on another PBX. I have configured the CME and can make outbound calls ok, but i cannot get the main number to connect to the extensions. I have debuged the CME router (debug ccsip) and i get 404 - not found. I need to know how to point this incoming number to the CME extensions. When i do a sh dial-peer voice sum, it shows POTS ports on the CME ???? i need to get the main PRI number to point to the reception extension.

anyine don ethis before ? if so any ideas on how i get this number to point at the CME extensions ?

thanks

1 REPLY
Hall of Fame Super Gold

Re: CME no PRI card using AS5300 GW - HELP

That means the number has no match. Likely you will a translation or secondary number on the CME router.

123
Views
0
Helpful
1
Replies