CME, not shows the 'missed call' on the 7941g IP phone
-7941g firmware 8.2.2SR1
when I dial to 7941g IP phone, shows properly the caller information during ring but not shows the '1 missed call' on the target IP phone's LCD panel after hang up the originator. also not shows on the '1=Missed call' entry via the 'Directory' button.
Re: CME, not shows the 'missed call' on the 7941g IP phone
Since this is not considered as a bug, but an Enhancement Request, it might take time before this is fixed. If you want this feature to be added ASAP, you would contact your Cisco SE/AM and have them work with the BU to get this feature available ASAP
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...