Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME outbound call to different Port

Hi everybody,

By using CME, there are 2 groups of phones

Group A - 1001 ~ 1010

Group B - 2001 ~ 2010

If Group A phone calls to PSTN via Port 0/0/0

and Group B phone calls to PSTN via Port 0/0/1

Is it possible to do it via dial-peer ?

Or I have to apply Corlist command to do that?

Thanks in advance

Sam

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

CME outbound call to different Port

Hi,

you can do corlists or you can set up an incoming translation profile on the ephone-dn level, adding a special prefix to the called number and then match that special prefix on the outbound dial-peer level.

G.

1 REPLY

CME outbound call to different Port

Hi,

you can do corlists or you can set up an incoming translation profile on the ephone-dn level, adding a special prefix to the called number and then match that special prefix on the outbound dial-peer level.

G.

125
Views
0
Helpful
1
Replies