Greetings, one of our customers has a DDI range consisting of 100 numbers.
The first 50 in the range have been allocated, what the customer would like is that if a call is placed to any un-assigned DDI a message is played asking the caller to phone the main number.
My first though was to create a dial-peer in CME with a pattern that matches the un-assigned range, then push it to a CUE script that plays the message.
Does anyone know of either a better way of doing this or if you can specify pattern matches for CUE autoattendant applications so that i dont have to specify 50 call in numbers pointing to the same AA application.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...