We have 4 agencies with individual CME4.2 on each site. A H323 hub is in the middle to connect and route calls between them.
Today, our customer wants to implement presence feature on these phones, especially BLF. He wants to monitor other phones of the local site AND remote phones of other sites.
I see in the CME System guide that the presence monitoring of a remote CME is possible since 4.1. There are some "presence" commands to enter, and we have to enter the IP address of the remote CME. But, there is no mention about the case of several remote CMEs.
The "server ip" command under "presence" in IOS is unique and I cannot enter several IP addresses.
So, I would like to know if someone succeed to play with presence with more than 2 CMEs.
Moreover, the guide mentions the usage of SIP trunks to get presence SUBSCRIBE/NOTIFY messages. But, I dont know if I have to create especially a SIP dial-peer between sites, or if the presence service of IOS does the trunk automatically thanks to the presence commands (cf. system guide) without specific dial-peer.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...