Today i tried to telnet this unit and i noticed that neither telnet session nor ping was working. So i brought a console cable and i got access to the router through Hyper Terminal to find out that all my previous configuration were gone and the unit seems to be reset.
I know you are going to think that maybe i didn't save the previous configuration, and which is 100% percent wrong.
I also would like to add that no one has access to this unit except me.
Have you ever got this kind of issues, and is there a way to recover the configuration?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...