Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CME - ringing two phones at once

If a call comes in on an FXO and I want to ring both an analog phone (on an FXS port) and an IP phone at the same time when this occurs - how to configure this? hunt-group?

6 REPLIES
Hall of Fame Super Gold

Re: CME - ringing two phones at once

You need to configure the FXS port in SCCP mode - the manual explains how to do that.

Community Member

Re: CME - ringing two phones at once

I think I found the answer in hunt-group parallel..

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmecover.html#wp1145800

..aka "Call Blast"

Hall of Fame Super Gold

Re: CME - ringing two phones at once

Not sure if hunt -group paralles support s pots DP.

Community Member

Re: CME - ringing two phones at once

..and worse if you're using prior to 4.3 CM software only SIP phones are supported. :-( But perhaps if I upgrade to 4.3 and use your SCCP command on the FXS port I'd be in business??

Hall of Fame Super Gold

Re: CME - ringing two phones at once

SCCP controlled ports is from 4.0 or so (I may be wrong). Then you don't necessarily need hunt-group, a shared line can be is enough.

Re: CME - ringing two phones at once

Hi mmedwid,

A shared line will accomplish this.

Regards,

Justin

193
Views
5
Helpful
6
Replies
CreatePlease to create content