10-07-2008 04:16 PM - edited 03-15-2019 01:47 PM
We are upgrading our circuit from 16 channels to a full E1 with 30 channels. I am able to change the pri-group timeslots to 1-31. When I sh ip interface brief I see all the channels displayed. My question is does the int S0/0/0:15 need to be modified to s0/0/0:31 to reflect the other channels or will all the channels still be available under the S0/0/0:15?
Any help would be greatly appreciated. Thank you!
10-07-2008 05:23 PM
u dont need to change it
S0/0/0:15 is the one u need
basicly the channel 16 is the D channel for E1 if u use all chaneels or 4 channells
if helpful Rate
10-07-2008 07:06 PM
Hi Marwan,
Thanks so much for replying. I am changing from 16 channels to 31 channels. Doesn't the serial interface have to reflect the 31 channels instead of the 16? How would I make that change?
Thank you!
10-07-2008 07:26 PM
the channel 16 will remain the D channel regardless howmany channels u are running
if helpful Rate
10-07-2008 11:35 PM
for your information
pri-group timeslots (1-31) for E1. This command associates the specified timeslots as ISDN channels. If you do not specify timeslots, all B-channels are associated to the PRI group. It is important to understand that the D-channel is always added to the pri-group, even if it is not explicitly specified, because it is required for signaling
hope this helpful
10-08-2008 04:48 AM
Hi Marwan,
Thank you so much for your quick response. I appreciate all your help!
10-08-2008 04:49 AM
u welcome
please, rate the helpful post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: