Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME Shared Line

Hello,

I would like to set up a shared line for 13 ephones in CME 7.1 on their second button. There is fractional PRI at the site so we would like only to have 6 calls be active at once with the 7th going busy.

Any thoughts?

Thanks.

3 REPLIES
Hall of Fame Super Gold

Re: CME Shared Line

That is fine, you can use octo-line DN for thta.

New Member

Re: CME Shared Line

Would the setup resemble this?

ephone-dn 1 octo-line

number XXXX

ephone 1

mac-address xxxx.xxxx.xxxx

button 2:1

ephone 2

mac-address xxx.xxxx.xxxx

button 2:1

Where would I put the busy-trigger-per-button or max-calls-per-button command? Would they go on each ephone? Is there something to place on the ephone-dn?

Hall of Fame Super Gold

Re: CME Shared Line

Yes, just just do these setting as you deem appropriate. Everything is explained in the manual, and there isn't anything special about.

Please remeber to rate useful posts with the scrollbox below.

362
Views
11
Helpful
3
Replies