Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CME - Simultaneously ring on 7912 IP-phone and dial-peer (pots and voip)

At first - excuse me for my English

I have

1760-V router with CME 4.0

5 - 7912 ip phone (Skinny)

2 - SIP ip phone from D-Link

one FXS card with two FXS port

I write dial-peer for Sip phone

#dial-peer voice 1010 voip

#destination-pattern 1010

#session protocol sipv2

#session target ipv4:192.168.52.100

I write dial-peer for FXS

#dial-peer voice 1012 pots

#destination-pattern 1012

#port 2/0

and CME create DN from 1000 to 1004

When i want simultaneously ring on two or more 7912 i use overlay in

ephone configuration

#ephone 1

#button 1o1,2

I want produce simultaneously ring not only 7912 phone.

For example - if i have call on 1100 number, I want have a ring on phone with number 1000, SIP phone on number 1010 and phone on FXS port 1012.

I read many documents about voice on cisco.com, and I don't understand if it possible or not, and if it possible how i can configure it.

Thank You for attention.

5 REPLIES
Hall of Fame Super Gold

Re: CME - Simultaneously ring on 7912 IP-phone and dial-peer (po

Hello,

for this you will configure a voice hunt-group with the parallel option. You will list the numbers to match by eFXS, FXS, application, or VoIP dial-peer.

New Member

Re: CME - Simultaneously ring on 7912 IP-phone and dial-peer (po

I do this, but i have error message

>Part of config

dial-peer voice 1010 voip

destination-pattern 1010

session protocol sipv2

session target ipv4:192.168.52.100

telephony-service

ephone-dn 1

number 1000

ephone 1

button 1:1

#voice hunt-group 1 parallel

#list 1010,1000

Number 1010 is not a valid voice register dn. Re-enter 'list.'

Hall of Fame Super Gold

Re: CME - Simultaneously ring on 7912 IP-phone and dial-peer (po

You haven't configured the SIP phones numbers under the voice register dn and pool sections.

That will avoid you configuring a dial-peer/

Guide to SIP phones and CCME:

http://cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_book09186a008052da6b.html

New Member

Re: CME - Simultaneously ring on 7912 IP-phone and dial-peer (po

I read this document and i don't understand how i can configured SIP phone other than Cisco SIP phone.

New Member

Re: CME - Simultaneously ring on 7912 IP-phone and dial-peer (po

I've the same problem on my 1751V.

At the moment i solved the problem with a time-out and i put the FXS extension in the final tag

#dial-peer voice 10 voip

#....

#dial-peer voice 12 voip

#....

#dial-peer voice 11 pots

#...

#...

#voice hunt-group 1 parallel

#list 10,12

#timeout 20

#final 11

1231
Views
0
Helpful
5
Replies
CreatePlease to create content