Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME SIP and RFC2833 fot DTMF

Hello,

Anyone can help me understand if it is possible and how to configure the CME SIP to pass DTMF digits via Inband RFC2833 instead of Notify Message ?

I have CME version 12.4

Thank you very much!

2 REPLIES
Bronze

Re: CME SIP and RFC2833 fot DTMF

Hi,

Yes it is supported, and necessary when using any external IVR applications.

This is accomplished by using the "dtmf-relay rtp-nte" command under a specific dial-peer.

Unity Express doesn't support RFC2833 DTMF digits so the standard SIP NOTIFY method must be used.

For more info see the Call Manager Express Admin Guide, p124, Configuring SIP Trunks.

Hope tis helps, if so please rate.

Regards,

Dave

Cisco Employee

Re: CME SIP and RFC2833 fot DTMF

Actually CUE supports rtp-nte DTMF relay from version 2.3

Refer here for details -

http://www.cisco.com/en/US/docs/voice_ip_comm/unity_exp/rel3_0/command/reference/d_cmds.html#wp1016311

556
Views
0
Helpful
2
Replies