Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME SIP Trunk sent ringback tone to caller

Does it possible to send custom ringback tone to caller for incoming call via SIP trunk to CME ? Similar to ATA186 SIP "ConnectMode" bit19 feature? Which means the caller will hear the CME generated ringback tone rather then the telco ringback tone?

3 REPLIES

Re: CME SIP Trunk sent ringback tone to caller

This is a hidden dial peer command that you can try:

progress_ind alert strip 8

New Member

Re: CME SIP Trunk sent ringback tone to caller

Try it out, however the incoming SIP dial-peer doesn't allow "progress_ind".

I tried on outgoing dial-peer, and seems like no effect.

Are there anything else I can try ?

Re: CME SIP Trunk sent ringback tone to caller

You can try taking the 8 off the last command.

Otherwise, I don't know of any other commands that can accomplish this. This command is typically used on pots legs, so it may not work for SIP trunks.

422
Views
0
Helpful
3
Replies