I got a CME connected with PBX, the pbx sip license is only 10 sip trunks, the CME has about 80 registered phone.
There is a VIP cisco number that i need to make it reachable from the nortel pbx any time.
There are 7 outgoing dial peers for mobile calls, national, international , etc ...
I only limited the dial peers with max-con 2, so that the possibility that the 10 sip trunks is small, and added a new dial peer for the VIP number with no max-con, but the cisco phone users complain they can't make calls with the pbx lot of times.
Also i can't control the incoming sip trunk, for example, if 9 sip trunks are used, i don't need any more sip trunks incoming or outgoing except for the vip numbers.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...