Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME STCAPP feature code on FXS port

Hi,

I am trying to configure the feature access code for FXS port in the same CME. I try to follow "Configuring FXS Ports for Basic Calls" http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxsbasic.html, I met a problem. In order to enable service stcapp in the dial-peer, I need to remove the destination-pattern command. After I remove the destination-pattern and enable the service stcapp, CME does not allow me to add back destination-pattern. Thus if I can't enable the destination-pattern, how I could tell the CME to route the call to that FXS port? I also try the answer-address, changing the incoming called-number pattern and adding back the station-id in voice port, but I am getting busy tone.

I would like to check does anyone have any idea on how to successfully enable the feature access code on the FXS port on the same CME?

Thanks.

Hung.

1 REPLY
Silver

Re: CME STCAPP feature code on FXS port

To configure feature mode for SCCP analog phones on a Cisco voice gateway and enable SCCP analog phones to invoke features using standard FACs after hook flash, perform the following steps.

enable

configure terminal

stcapp call-control mode feature

end

Configuring Feature Mode:

http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxsfeatmd.pdf

1060
Views
0
Helpful
1
Replies
CreatePlease login to create content