Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME termination sign # with dial-peer?

All,

I am wondering if CME POTS dial-peer has '#' sign as its default termination key.

I found in CME VOIP dial-peer, it will recognize '#' as default termination key which stop T302 timeout timing.

ie, I have dial-peer voice 999 voip

destiantion-pattern 25T

when I dial '2550#' in one of ephone, it will ring remote x2500 immediately.

For POTS dial-peer, I cannot confirm '#' sign as default key.

Can anyone confirm for me?

This will affect the dial-peer setup.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CME termination sign # with dial-peer?

Yes, # is the termination character for POTS dial peers when using T in the destination pattern.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

Hope this helps.

Brandon

3 REPLIES

Re: CME termination sign # with dial-peer?

Yes, # is the termination character for POTS dial peers when using T in the destination pattern.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

Hope this helps.

Brandon

New Member

Re: CME termination sign # with dial-peer?

Great - good man Brandon.

thanks - also rate for 5.

In summary:

By default both CCM and CME/SRST IOS support '#' sign as termination for timer.

In CCM, it works with wildcard '!' and '@'.

In IOS, it works with 'T'.

James

Re: CME termination sign # with dial-peer?

James,

You are correct. Thanks for the rating.

Brandon

244
Views
0
Helpful
3
Replies
CreatePlease login to create content