Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME through PSTN Emulator to CME - call completes then rings busy

Desired call flow:

H323 GW -> PSTN emulator via E1->inbound dial peer-> outbound dial peer -> different H323 GW via another E1

When dialing from H323 # 1 to H323 # 2, destination phone rings. As soon as call is answered, phone #1 starts playng busy signal.

debug voice dialpeer at all 3 locations shows correct dialpeer matching and correct call flow.

In my PSTN emulator, I have added voice service voip I have added H323 to H323.

All E1s show multiframe established.

In the reverse direction, the phone at GW 2 rings the phone at GW 1, the destination phone rings once and then the call drops

I can post any portions of the config if desired

Jeff

1 REPLY
New Member

Re: CME through PSTN Emulator to CME - call completes then rings

Fixed my own problem - IOS upgrade on CME 2 did the trick

171
Views
0
Helpful
1
Replies
CreatePlease login to create content