cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
746
Views
0
Helpful
7
Replies

CME to CME integration

cris_jimenez
Level 2
Level 2

hello folks

do you know or could you share a document that will explain cme to cme integration ?

thank you

1 Accepted Solution

Accepted Solutions

Basically, you would just have dial-peers on each cme pointing to the remote site:

example:

California router

dial-peer voice 100 voip

description **Calls to Indianapolis**

destination-pattern ....(extensions in Indy)

session target ipv4:x.x.x.x (IP of Indy router)

dtmf-relay h245-alphanumeric

Indy router

dial-peer voice 100 voip

description **Calls to California**

destination-pattern ....(extensions in Cali)

session target ipv4:x.x.x.x (IP of Cali router)

dtmf-relay h245-alphanumeric

Hope that helped, if so please rate.

View solution in original post

7 Replies 7

Hello,

Can you be more specific? Are you just trying to network CME's at 2 different sites? Please explain further.

yes

I'd like to integrate 2 CME systems in 2 different locations

Indianapolis, California

there's going to be a VPN tunnel between the 2 sites and I'd like to have 4 digit dialing between the 2 sites

the site in indianapolis currently has cme version 4.2, the site in california has cme version 4.1

and i think i may need a GK for BW control, but i'm not sure i haven't found something that will explain how to integrate the 2 systems together

Basically, you would just have dial-peers on each cme pointing to the remote site:

example:

California router

dial-peer voice 100 voip

description **Calls to Indianapolis**

destination-pattern ....(extensions in Indy)

session target ipv4:x.x.x.x (IP of Indy router)

dtmf-relay h245-alphanumeric

Indy router

dial-peer voice 100 voip

description **Calls to California**

destination-pattern ....(extensions in Cali)

session target ipv4:x.x.x.x (IP of Cali router)

dtmf-relay h245-alphanumeric

Hope that helped, if so please rate.

hello,

I configured the dial-peers however i can only call the phones from california to indy. if i try to call from indy to california i get fast busy ... what am i doing wrong ?

problem resolved

thanks

how did you resolve it

I did a debug voice ccapi inout and realize that when i was placing the call it was actually getting to the remote ccme however the incoming dial-peer was wrong i reconfigure it and it fix my issue

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: