Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME to CME, missing CLI on SIP trunk

I have two CME 4.0 boxes either end of a 2mb link. There is a SIP trunk configured between these units which works fine apart from some missing CLI info on the called party for the caller.

So if John Smith (x2002) calls Emily Bond (x3003), John will only see the xtn number for Emily, not her name. However Emily will see both name and number of who is calling her.

Any ideas greatly appreciated.

thanks

Jamie

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: CME to CME, missing CLI on SIP trunk

Hi, that is "connected party name update". I would upgrade to IOS 12.4(11)XJ4 and it should be resolved.

Hope this helps, please rate post if it does!

2 REPLIES
Hall of Fame Super Gold

Re: CME to CME, missing CLI on SIP trunk

Hi, that is "connected party name update". I would upgrade to IOS 12.4(11)XJ4 and it should be resolved.

Hope this helps, please rate post if it does!

New Member

Re: CME to CME, missing CLI on SIP trunk

Hi Paolo

Your advice worked a treat, updating to CME 4.1 has resolved the problem.

Thank you very much for your help.

best regards

Jamie

121
Views
0
Helpful
2
Replies