1. Was running cmterm_7936.3-3-14-0.bin and ran into a problem where when I pressed the conf button to conference the 3rd party nothing would happen. Conf members total would have been 3.
2. I fixed this issue by falling back to cmterm_7936.3-3-5-0.bin, but now for reasons unknown and intermittently my customer will find their 7936 with "configuring ip" on the display. Power Cycle and the 7936 works fine for awhile.
Anyone know if the latest version of firmware for the 7936 (cmterm_7936.3-3-15-0.bin) is compatible/supported to run on CME v4.03. I read the release note and there is nothing in the document that specifically states that this version is supported on any version of CME??
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...