setup: CME with a couple phones served by a 2 line BRI on 12.4(15)T7. Problem: outbound calls are fine on either spid. Inbound calls work on first spid but second spid rings twice and then stops. Calling party hears continuous ringing and call appears rejected.
I previously posted this problem under the topic "CME with BRI cannot answer second inbound voice call" but there is a new and intriguing development: The example above is based on a switch type config of basic-NI, but if I change the configuration to basic-5ess the first channel now has the problem and the second works fine.
I'd think this is a carrier problem but I don't believe they can provision each channel/SPID of a BRI with different signaling.
I've opened another ticket with the carrier to ask the question but is it possible? Can the carrier provision one channel of a BRI with NI/DMS100 and the other channel with 5ESS?
Any thoughts on this? I'm willing to try anything.
I've been with carriers for a couple decades and have never seen it done, but I also know that carriers have custom switch loads built. The Nortel/MCI DMS250 is a perfect example. That said I'd agree with you. Thanks for your help in solving.
For Traces: If you read within the message you'll see the other thread has everything attached. I can copy it over but it would seem a waste of space. let me know if you want to see debugs that aren't already there. thx
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.