can you Please submit your configuration for SPA112 under CME , I have 2 unit and try to config as SIP without mac and type but it's fail to register , also if you have any special config at SPA112 instead of default
username and password .
Thank you for your information, the device registered now , after I found the actual problem at my side , I use CME as secondary IP address under interface , the SPA can't see it when I change at SPA to read from main IP under interface its work fine.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.