I have this problem, I have a CME on 2851 this router is also DHCP with two different pool address for data (10.0.x.x/16) and voice (192.168.0.x/24), and some switch with configured cisco-voice vlan. all works fine, but if I try to use Softphone it does not work because it is on data vlan and have a data IP, putting a static route on pc, it registered but the voice in unidirectional or completly absent.
How can I resolve my problem? It is possible to mantain both vlans and use softphone correctly?
You need to make sure the PC or laptop in which the softphone reside should have access to the voice lan and should get IP address in the voice Vlan range. Cisco IP Communicator v 2.0(1) and higher supported only support with CME
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.