Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME with WAN

Hi,

i am in the process of Pre-sales, where a small customer has an HQ with CME and he has 8 intl branches.

All the branches are connected through VPN for Data transfer, solution provided is to install an IP phone in each location and register the IP Phone with the CME in the HQ. it works perfect, my concern is the QOS, i am wondering if there is a way to limit the number of calls within the CME or consider the remote branches as regions like in the CCM.

Good day

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: CME with WAN

No, CME doesn't have concept of regions at all.

All you can do is configure g729 for the remote phones to reduce bandwidth. If you get the newer phones (79x5), in the future you will be able to support iLBC that is much better than g729 for that purpose.

Hope this helps, please rate post if it does!

3 REPLIES
Hall of Fame Super Gold

Re: CME with WAN

No, CME doesn't have concept of regions at all.

All you can do is configure g729 for the remote phones to reduce bandwidth. If you get the newer phones (79x5), in the future you will be able to support iLBC that is much better than g729 for that purpose.

Hope this helps, please rate post if it does!

New Member

Re: CME with WAN

thanks for confimring my doubts.

i know there is no region concept, but i was looking for something similar, also the G729 codec is already implemented but you were talking about the iLBC codec, is it already out and supported on CME and which IP phones!!!

again thanks for your help.

Good day

Hall of Fame Super Gold

Re: CME with WAN

Not yet, but I think will be in CME 4.3. The new phones (models ending with 5) have it, the older ones do not.

Thanks for the nice rating and good luck!

132
Views
0
Helpful
3
Replies
CreatePlease login to create content