In cme when there is a seperate switch, in the command ip source-address the ip address of the cme's interface to the switch is entered. But in case of 1861 integrated 8 port switch, do i have to give the ip of svi or voice vlan in the ip source-address command.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...