We have a hunt group on callmanager 9.1. We also have SRST. I have been trawling for information regarding how to have this hunt group in CMESRST.
Here is the relevant info in telephony service (not call-manager-fallback)
protocol mode default
ip source-address 192.168.1.1 port 2000
hunt-group report delay 1 hours
hunt-group logout DND
I also created a voice hunt group
voice hunt-group 1 paralell
Have also added the following global command
dial-peer hunt 2
When we do a failover test, the phones, go into CME mode ok. The DDI's ring them directly ok. but the hunt group, will only ring one of the phones within that hunt group and when it goes unanswered it hits the generic vociemail anouncement when no mailbox is associated.
Then when we failback, it would seem that the hunt group on the CMe router is still being used, rather than the Callmanger one.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...