CMM RJ48c To DB15 T1 connector Cable Pin-out Needed
Would anybody know if cisco has a link to a cable pin-out for the following?
We have cisco WS-SVC-CMM Cat6k Voice Linecard that has RJ48c and at the other end is a male DB15 connector. Our PRI isn't working at the moment and we are suspecting it's the cable. We want to change the cable but I need to make sure of the pin-out before.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.