Would like to ask how and what the steps of configure extensions using codec G729 instead of codec G711 ? At the moment, have a few phones via 2 MB link registered to a CCM remotely thus when make calls not advised to use G711
You will need to configure 2 regions and set the regions to use G.729 for calls between them. Then, create 2 device pools and assign the 2 previously created regions to them. Assign these device pools to phones in the respective locations.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...