Command to show which calls are using xcode resource
I can see on the gateway that transcoding resources are being used with the command "show dspfarm all". Now I would like to find out any identifying information about the calls needing transcoding, so I can figure out why they need it.
Is there any command on a voice gateway which shows me any information (phone number for example) about the call being transcoded. Or will I have to dig through the CUCM traces?
All of the suggested commands will show you the active xcoding sessions but will not tell you exactly why. Show call active voice brief will show you different capabilites from each call leg and you may deduce why your cals need a xcoder..But to know why in detail you need CUCM traces. CUCM will tell you why a xcoder is been invoked..It is the best place to know for sure WHY!
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...